The ears are set high and the tips are carried close to the cheek. The Wire Fox Terrier has small, V-shaped, button ears of moderate thickness. The Wire Fox Terrier has a complete set of comparatively large, evenly spaced, white teeth with a scissors bite.ĭisqualifications: ¼ inch or more overshot or undershot.ĭisqualifications: Dudley nose butterfly nose.Įyes are deep set, moderately small, nearly round, dark in color, with a lively, intelligent, sometimes fiery expression. There is a minimum of falling away under the eye, giving a moderately chiseled look. The muzzle is strong and tapers slightly from stop to nose. The skull is flat and moderately narrow, tapering slightly toward the muzzle. When viewed from the side, the skull and muzzle are equal in length, parallel to one another, and joined by a barely perceptible stop. Although seldom used for hunting now, the Wire Fox Terrier retains a strong prey drive and will dig tirelessly after any underground vermin. They are affectionate with children but may be too active for some. The Wire Fox Terrier is bold but not aggressive with people. Through his keen expression and alert bearing, ears up and tail quivering, the Wire Fox Terrier gives the impression of a dog ready to go anywhere and take on any task. The Wire Fox Terrier is friendly, alert, active, and lively without being high-strung. When standing, the distance between the front and rear feet is long in comparison to the relative shortness of the dog’s back. The Wire Fox Terrier is modeled on the symmetry and power of the Fox Hound. The coat is predominantly white in color. The tail is straight, set high, and normally docked, but not close to the body. Ears are set high and are V-shaped, dropping forward, and carried close to the skull. The head is moderately narrow, with a flat skull, a barely perceptible stop, and a powerful muzzle that is equal in length to the skull. The body is square and covered with a dense, wire coat. The Wire Fox Terrier is a muscular but agile, active, small-to-medium size hunting terrier, with sufficient length of leg to run with the foxhounds in a hunt, and built to go to ground after fox. The two breeds were separated effective January 1, 1999. The Fox Terrier was recognized by United Kennel Club in 1912. Except for coat, however, the two breeds are essentially identical. Although considered one breed for many years, interbreeding of Smooth Fox Terriers and Wire Fox Terriers ceased in the early 1900s. By the end of the 19th century, smooth and wire-coated Fox Terriers were in great demand, both as companions and show dogs. Early fox terriers were primarily smooth-coated, but the wire coat persisted. Hunters began to develop a longer-legged terrier, predominantly white in color so as not to be mistaken for a fox. Terriers, game and eager, were ideal for such a purpose but most of the early terriers were dark in color and too low on leg to run with a pack of foxhounds. When fox hunting became popular in England in the late 17th century, hunters found the need for a dog that could go to ground and bolt the quarry. The goals and purposes of this breed standard include: to furnish guidelines for breeders who wish to maintain the quality of their breed and to improve it to advance this breed to a state of similarity throughout the world and to act as a guide for judges.īreeders and judges have the responsibility to avoid any conditions or exaggerations that are detrimental to the health, welfare, essence and soundness of this breed, and must take the responsibility to see that these are not perpetuated.Īny departure from the following should be considered a fault, and the seriousness with which the fault should be regarded should be in exact proportion to its degree and its effect upon the health and welfare of the dog and on the dog’s ability to perform its traditional work. Toggle Search Search UKC Website Go ▼ Show Menu ▼
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |